VDubber

Aircooled blogs, builds and banter...
  • Been busy mocking up a prototype kit for a Mexi EFI system. The kit will allow you to fit an AMR500 blower to your existing Mexi-EFI kit and reuses the existing mexi-throttle-body.

    I 3D printed the blower stand to test fit it to the case and make sure that everything lines up correctly.

    Should hopefully have the finished item ready for sale soon
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.