Joe Blow delivery bus - 55 Panel

Joe Blow delivery bus - 55 Panel
13 April 2014
To bend a flange insert into the bender...
21 April 2014 ·   9 years ago
Covered them in some heat shrink to finish them off
21 April 2014 ·   9 years ago
Checkjing alignment of A pillar panel - still needs a bit more shaping
21 April 2014 ·   9 years ago
Added a base to the stand, it also provides somewhere to store stuff.
21 April 2014 ·   9 years ago
Checking that the captive 'nut' fits inside the hinge panel template
21 April 2014 ·   9 years ago
First tep in making the template for the hinge panel
21 April 2014 ·   9 years ago
Finished A pillar repair - note top is now shaped to flow into existing panel
21 April 2014 ·   9 years ago
Flange bender can also be used as a flat chisel to help form a tight bend
21 April 2014 ·   9 years ago
Still got some minor panel shaping to do but looking good
20 April 2014 ·   9 years ago
Offering up the reshaped nose - looks heaps better then before
20 April 2014 ·   9 years ago
Looking good - basic profile is now back
20 April 2014 ·   9 years ago
Slowly bringing up all of the low spots from the crash damage
20 April 2014 ·   9 years ago
Very old repair panel. Possibly let in to repair some accident damage.
20 April 2014 ·   9 years ago
Hard to tell but the nose is much straighter
20 April 2014 ·   9 years ago
Other side of repair panel - existing panel still needs to be trimmed back a little
20 April 2014 ·   9 years ago
Offering up the repair panel I made - just a little adjustment at the top required
20 April 2014 ·   9 years ago
No photos available
Drop a file here to upload.
Unable to load tooltip content.