Nice amount of tuck - not too much. Just right.
21 September 2014
·
9 years ago
Beam installed. Nice and narrow. Still needs to be dropped a couple of inches though
21 September 2014
·
9 years ago
Next, mark out the holes for the adjusters and weld them on. (mark the position of the original holes on the beam before you cut the center out to make this step easier)
21 September 2014
·
9 years ago
Onc the end plates are welded on you can take the beam out of the jig and weld the insides
21 September 2014
·
9 years ago
With the beam cleaned up you can fit it into the end plates and assemble it in the jig.
21 September 2014
·
9 years ago
The Jimp cleaning up the beam (lots of work)
21 September 2014
·
9 years ago
End plates mounted up in the jig we made earlier
21 September 2014
·
9 years ago
Using a plaza you get left with a pile of stuff that looks like this
21 September 2014
·
9 years ago
brace the tubes and cut the end plates off
21 September 2014
·
9 years ago
Having a CNC plasma comes in very handy
20 September 2014
·
9 years ago
Marked out ready to cut and building a jig
20 September 2014
·
9 years ago
Cutting out the end plates on the CNC plasma
20 September 2014
·
9 years ago
No photos available
Drop a file here to upload.
