-
Spent some time in the week finishing off the second EFI manifold. I made the first one as a bit of a trial, to see if I could do it. I tried to refine the process a little with the second one and took a slightly different approach to how I set it up and welded it. I'm still not convinced that I've figured out the best way yet as it is a bit time consuming. Fine for a one off like this but not to make multiple sets.
At any rate the manifolds and fuel rails are pretty much done and are nearly ready to be fitted. I just need to make a tie down plate to hold the fuel rail in place and buy the correct fuel rail fittings.Post is under moderationStream item published successfully. Item will now be visible on your stream.