VW Blog

Aircooled VW blogs, builds and banter. Since lunchtime 2009

Making my steering column fit.

IMG_9963

The great thing about non-standard parts is that somehow you need to make them fit. 

You will recall in previous posts that I've been chipping away at making the steering wheel fit. First making it fit the column, then making the column support, then making a nice fancy horn push and now the ultimate culmination of the steering wheel saga making the steering column fit the car.

Continue reading
  728 Hits
728 Hits

Steering column bush

IMG_9788

Not too much progress to report. Although I did make a steering column bush for the hybrid steering column setup I'm building.
I'm not 100% sold on the black nylon, however the white was simply too white and new looking. I figured black would look a little more like bakelite.
Now all I need to do is cut and shut the crash can and hook the column up

Continue reading
  553 Hits
553 Hits

DIY Speedster Steering Column Clamp

DIY Speedster Steering Column Clamp DIY Speedster Steering Column Clamp
Haven't done anything on the speedster for a while so was happy to grab a few hours today. I decided to take a look at the steering column with a view of getting the new column installed and mounted up. There's a few jobs to do before I can swap out the late column that's currently fitted. I managed to source an early beetle outer column tube from a mate but needed to figure out how to get it to work with what I had and how I wanted it to look following my overall plan of trying to make it look like an early car. Ideally I would love to swap the dash for a pre-A dash but my plan is simply to use as many early styling cues as I can whilst still working with what I have‚Äč
Continue reading
  998 Hits
998 Hits

Steering me in

IMG_0936-1024x764

This weekend I turned my attention to getting the rest of the brakes installed. The pedal assembly needed to be fitted and the SACO hydraulic clutch kit installed. The SACO kit replaces the clutch cable with a hydraulic setup which includes a small master cylinder that locates inside of the 'transmission' tunnel, and a slave cylinder that mounts where the stock clutch cable normally mounts.

Continue reading
  2393 Hits
2393 Hits

Rolling, rolling, rolling...

IMG_1130-1024x764

Rawhide references aside, this weekend broaches yet another milestone in the build. For the past 5 or so years the car has sat on axle stands whilst I tinkered about with different suspension setups, but now, after deciding to postpone my plans for the crazy suspension and fitting a stock (ish) IRS setup, it finally stands on it's own four wheels again.

Continue reading
  1811 Hits
1811 Hits